2003 MG Zt-t

Brake pedal wearing smooth (1.1.2 (c))

Nearside front and offside rear jacking blocks missing.

Exhaust has a major leak of exhaust gases Rear silencer. Emissions test will have to be retested after exhaust repair. (6.1.2 (a))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure Inner sidewall. 225/40/18/95W. (5.2.3 (d) (ii)) DANGEROUS

Brake pedal wearing smooth (1.1.2 (c))

Nearside front and offside rear jacking blocks missing.

Brake pedal wearing smooth (1.1.2 (c))

Full under carriage coated with underseal.

Headlamp has a product on the lens but not seriously reducing light output Both lamps. (4.1.4 (b))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Full under carriage coated with underseal.

Headlamp has a product on the lens but not seriously reducing light output Both lamps. (4.1.4 (b))

Brake pedal wearing smooth (1.1.2 (c))

Complete under carriage covered in underseal

Headlamp has a product on the lens but not seriously reducing light output All Four lenses deteriorated (4.1.4 (b))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Headlamp lens slightly defective All four (4.1.1 (b) (i))

Undercarriage coated in uncerseal

both front anti roll bar drop link lower gaiters split but not allowing the ingress of dirt etc

rear tail box in poor condtion

exhaust back box in poor condishon

rear exhaut tail box outer caseing falling apart

Front registration plate displaying a honeycomb or similar effect background (6.3.3)

Rear registration plate displaying a honeycomb or similar effect background (6.3.3)

rear exhaut tail box outer caseing falling apart

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)