2004 Audi A2

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Oil leak, but not excessive ON MOT LIMITS (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Inner Road wheel slightly distorted Rim (5.2.2 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Brake hose excessively deteriorated Both fronts (1.1.12 (b) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Headlamp levelling device inoperative (4.1.5 (a))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Inner Road wheel slightly distorted Rim (5.2.2 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Tyre worn close to the legal limit (4.1.E.1)

both front brake discs pitted on inner surface

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

both front brake discs pitted on inner surface

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front brake disc excessively scored (3.5.1h)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)