2004 Fiat Panda

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement BOTH (5.3.4 (a) (i))

Front Macpherson strut mounting corroded but not seriously weakened BOTH (5.3.3 (b) (i))

Front Tyre worn close to legal limit/worn on edge BOTH (5.2.3 (e))

Nearside Front Outer Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Upper Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement BOTH (5.3.4 (a) (i))

Front Macpherson strut corroded but not seriously weakened BOTH (5.3.3 (b) (i))

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement BOTH + PERISHED (5.3.4 (a) (i))

Nearside Front Position lamp slightly affected by the operation of another lamp DIPPED BEAM (4.2.3 (c))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Rear Brake performance not tested (1.2.1 (g))

Offside Rear Brake master cylinder leaking (1.1.10 (b) (ii)) DANGEROUS

Brake fluid warning lamp illuminated (1.1.10 (f))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement BOTH (5.3.4 (a) (i))

Front Macpherson strut corroded but not seriously weakened BOTH (5.3.3 (b) (i))

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement BOTH + PERISHED (5.3.4 (a) (i))

Nearside Front Position lamp slightly affected by the operation of another lamp DIPPED BEAM (4.2.3 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Emissions not tested (8.2.1.2 (d))

n/s/f tyre tread depth low at 2mm (Advise attention

rear exhaust box poor (Advise attention

both front top strut mountings have some up/down movement

both rear flexi brake hoses, ferrules starting to corrode

n/s/f tyre tread depth getting low at 3mm

Offside Headlamp aim too high (4.1.2 (a))

both front top strut mountings have some up/down movement

both rear flexi brake hoses, ferrules starting to corrode

n/s/f tyre tread depth getting low at 3mm

Offside Front Oil leak engine ()

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Stop lamp adversely affected by the operation of another lamp side light (1.2.1f)

Offside Front Oil leak engine ()

Nearside Inner Track rod end ball joint has slight play (2.2.B.1f)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Inner Track rod end ball joint has slight play (2.2.B.1f)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear tyre worn on outside edge.

Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

nearside rear tyre worn on outside edge

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

exhaust rear silencer in poor condition

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Headlamp aim too high (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)