2005 Toyota Land Cruiser

Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Headlamp lens slightly defective both (4.1.1 (b) (i))

Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front door step mounting rusted badly

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

all suspension parts rusted

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Suspension component ball joint has slight play (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Position lamp not working SIDELIGHT BULB (4.2.1 (a))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect BULB INCORRECTLY FITTED (4.1.2 (c))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Headlamp aim too low (1.8)

Front Shock absorber has a serious fluid leak (2.7.3)

Front front brake excessively fluctuating (3.7.B.3)

Rear Registration plate lamp not working (1.1.C.1d)

Rear rear brake excessively fluctuating (3.7.B.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)