2006 Toyota Aygo

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

All direction indicators not working (4.4.1 (a) (ii))

Indicator switch inoperative (4.4.2 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Headlamp lens slightly defective Headlamp lens deteriorated but light output not reduced (1.7.4a) (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Headlamp lens slightly defective Headlamp lens deteriorated but light output not reduced (1.7.4a) (4.1.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases rear pipe joint (6.1.2 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive very slightly to underside (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive very slightly to underside (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both sides (4.7.1 (b) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive underside (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive underside (5.3.6 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords slight cut to tread (5.2.3 (d) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides. bushes split (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge close to limit (5.2.3 (e))

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement both sides (2.4.G.2)

nearside rear brake binding slightly

Centre Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front tyre worn outer edge

Exhaust heat shield missing

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Exhaust heat shield missing