2013 Qingqi Qm

Gear lever mechanism worn.

Speedo not working

Cush drive rubbers worn

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))

Front Tyre incorrectly seated on the wheel rim (5.2.3 (k))

Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Rear reflector missing (4.8.2 (a) (ii))

Gear lever mechanism worn.

Left hand handlebar grip loose on bar, bear end keeping grip on. Advise attention.

Speedo not working

Rear wheel sprocket cush drive rubbers worn

Chain and sprockets worn, advise renewal.

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Rear Brake indicates a slightly grabbing brake (1.2.1 (c))

Speedo/odometer not working

Nearside Rear Footrest missing (6.2.12 (a))

Offside Rear Footrest missing (6.2.12 (a))

Chain and sprockets worn, advise renewal.

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Rear Brake indicates a slightly grabbing brake (1.2.1 (c))

Front Brake lever has insufficient reserve travel (1.1.2 (a))

Front Stop lamp not working (4.3.1 (a) (ii))

Rear Stop lamp not working (4.3.1 (a) (ii))

Suspension arm pin or bush excessively worn Swing arm bushes badly worn. (5.3.4 (a) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Suspension rod corroded but not seriously weakened front forks (5.3.3 (b) (i))

front mudguard insecure - not affecting steering control

Rear Stop lamp switch with a delay in operation (4.3.2 (a) (ii))

Brake drum missing barrel on actuator arm (1.1.14 (c)) DANGEROUS

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Suspension rod corroded but not seriously weakened front forks (5.3.3 (b) (i))

front mudguard insecure - not affecting steering control

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride split pin missing from rear securing nut (6.2.1h)

Offside Upper Exhaust is leaking and excessively noisey (7.1.1b)

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))