2014 Jeep Wrangler

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Fuel Pipe/s corroded ()

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge 2.4mm (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge 2.7mm (5.2.3 (e))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Outer Direction indicator not working (4.4.1 (a) (ii))

Offside Rear Wheel bearing rough when rotated Excessive play aswell (5.1.3 (b) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside rear brake binding (3.7.B.1)