1997 Jaguar XK8

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor corroded (7.1.1 (a) (i))

Exhaust has a minor leak of exhaust gases both front pipe joints blowing (6.1.2 (a))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front tyre worn on inner edges

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Lower Suspension component likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Offside Front Lower Suspension component likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Steering component mounting prescribed area is excessively corroded floor near the front on the bend (2.1.2 (e) (i))

Offside Front Upper Steering component mounting prescribed area is excessively corroded hole on the front chassis leg the steering shaft runs by it (2.1.2 (e) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front floor has a holes in but not in a prescribed area

Front Brake pipe corroded, covered in grease or other material along front cross member, light surface corrosion (1.1.11 (c))

Nearside Side repeater not working (1.4.A.2c)

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

Offside Headlamp aim too high (1.8)

Nearside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Outer Front Track rod end ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Offside Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

emssions just met

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Anti-lock braking system warning lamp sequence is incorrect (3.4.1d)

Nearside Outer Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Front Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Inner Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Registration plate lamp not working (1.1.5c)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Registration plate lamp not working (1.1.5c)