2003 Toyota MR2

Brake pipe corroded, covered in grease or other material All steel pipes (1.1.11 (c))

Nearside Rear Suspension arm ball joint has slight play (5.3.4 (a) (i))

Exhaust noisy (8.1.1 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Top strut mounting slightly worn

Offside Handbrake performance just o.k.

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Lower Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Top strut mounting slightly worn

Offside Handbrake performance just o.k.

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front registration plate faded but not likely to be misread (6.3.1d)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front registration plate faded but not likely to be misread (6.3.1d)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Front front brake application uneven (3.7.B.2)

Offside Rear rear brake application uneven (3.7.B.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear wheel bearing has excessive play (2.6.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Offside Front Steering arm has relative movement at its fixings (2.2.B.1h)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear wheel bearing has slight play (2.6.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside front brake binding (3.7.B.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc excessively pitted (3.5.1h)

Nearside Front Windscreen wiper blade deteriorated (8.2.2)

Nearside Rear Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside rear brake binding (3.7.B.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front front brake binding (3.7.B.1)

Offside Rear Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake cable has restricted free movement (3.5.1k)

Rear brake caliper has restricted free movement (3.5.1k)

Brakes imbalanced across an axle (3.7.B.5b)

Front rear brake binding (3.7.B.1)

Nearside Rear Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear rear brake binding (3.7.B.1)

rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)