2011 Land Rover Discovery

Central Prop shaft bearing has slight play (6.1.7 (b) (i))

Nearside Rear disc back plate corroded

Offside Rear disc back plate corroded

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Outer Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Rear Brake pipe excessively corroded metal brake line corroded (1.1.11 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside washer jet poor but efficient

Brake pipe inadequately supported front to rear (3.6.B.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Mechanical brake component has restricted free movement hard to rotate wheel (3.5.1k)

Parking brake: efficiency below requirements (3.7.C.1b)

Offside Front Tyre worn close to the legal limit inner edge wear (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Power steering pipe(s) or hose(s) has slight seepage from a joint pressure pipe (2.3.3b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Power steering pipe(s) or hose(s) has slight seepage from a joint pas pump to pas rack (2.3.3b)

Rear unable to check 6th and 7th seats, belts and buckles

Nearside Rear Outer Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Power steering pipe(s) or hose(s) has slight seepage from a joint pas pump to pas rack (2.3.3b)

Rear unable to check 6th and 7th seats, belts and buckles

Nearside Front Lower Suspension arm has slight play in a pin/bush hydra bush (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a pin/bush hydra bush (2.4.G.2)

emissions light came on during MOT now off

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)