1993 Toyota MR2

all brake pipes corroded

general corrosion to vehicle underside

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Suspension arm attachment bracket/mounting insecure (5.3.3 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

all brake pipes corroded

general corrosion to vehicle underside

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

all brake pipes corroded

general corrosion to vehicle underside

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all brake pipes (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Service brake binding but not excessively (1.2.1 (f))

general corrosion to underside

Headlamp does not operate immediately when selected on main beam both (1.7.4a)

Headlamp switch faulty (1.7.1)

Offside Rear Suspension arm has slight play in a ball joint (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Steering rack gaiter deteriorated (2.2.D.2d)

Offside Front Steering rack gaiter deteriorated (2.2.D.2d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Tie bar/rod corroded and seriously weakened (2.4.G.1)

Parking brake: efficiency below requirements (3.7.B.7)