1991 BMW 3 Series

Battery insecure (1.9.1)

Bonnet cannot be secured in the closed position (8.4.1)

Emissions not tested Exhaust pipe is snapped off at down pipe (7.3.A.1)

Exhaust has a major leak of exhaust gases Broken at down pipe (7.1.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Front registration plate deteriorated (6.3.1d)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front Electrical wiring insecure Inner wheel arch brake warning wires hanging down (1.9.2a)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Suspension component mounting prescribed area is excessively corroded Floor holed within 30cm of suspension arm mounting (2.4.A.3)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Rear Direction indicator not working (1.4.A.2c)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded Outer sill holed within 30cm (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded Inner sill within 30cm of suspension mount (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension component mounting prescribed area is excessively corroded Floor holed within 30cm of suspension arm mounting (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded Turret (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded Bottom of suspension turret (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded Bottom of suspension turret (2.4.A.3)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Rear Body has a sharp edge caused by corrosion Wheel arch (6.1.C.1)

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Rear Electrical wiring insecure Brake warning wire hanging by diff (1.9.2a)

Offside Rear Seat belt anchorage prescribed area is excessively corroded Inner wheel arch holed (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded Outer sill holed (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded Inner wheel arch holed within 30cm of suspension mount (2.4.A.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper not operating automatically when switched on (8.2.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Fuel pipe/s corroded

Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Driver's seat cannot be secured in the upright position. (6.2.A.2)

Front Passenger's seat insecure (6.2.A.1)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

rear parking brake recording little or no effort (3.7.B.6a)

Front Brake pad(s) wearing thin (3.5.1g)

Front nearside tyre perished

Fuel pipe/s corroded

Rear tyres badley perished

Centre Brake pipe slightly corroded (3.6.B.2c)

Nearside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front position lamp(s) incorrect colour (1.1.A.3e)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nail in offside rear tyre

Nearside Rear Registration plate lamp not working (1.1.5c)

slight corrosion on brake pipes

slight play in track rods

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nail in offside rear tyre

slight corrosion on brake pipes

slight play in track rods

Nearside Front Headlamp aim too high (1.8)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Headlamp aim too high (1.8)

Service brake: efficiency below requirements (3.7.B.7)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake hose slightly deteriorated (3.6.B.4d)

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Propshaft component defective

Rear Brake pipe slightly corroded (3.6.B.2c)

handbrake close to reserve travel

slight play in nearside front wheel

Nearside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Nearside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Exhaust system not adequately supported (7.1.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Direction indicator not working (1.4.A.2c)

Nearside Rear passenger seat cannot be secured in the upright position. (6.2.3)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Hazard warning tell tale not working correctly (1.4.B.1e)

Nearside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Offside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)