1991 Toyota MR2

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Nearside Headlamp aim too low (1.8)

Offside Front coil spring cracked (2.4.C.1a)

Registration plate lamp not working (1.1.C.1d)

Brake performance not tested (3.7.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Drag link end ball joint has slight play (2.2.B.1f)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

n/s/f bumper damaged

o/s/r tyre has cut not exposing cords

radiator poor condition

Oil leak

Front registration plate not fixed vertically, or as close to vertical as is reasonably practical (6.3.2c)

Nearside Direction indicators missing (1.4.A.2b)

Nearside Exhaust system not adequately supported (7.1.1)

Nearside Front position lamp(s) missing (1.1.A.3a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Direction indicators not working (1.4.A.2c)

Nearside Rear Tie bar/rod corroded and seriously weakened (2.4.G.1)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tie bar/rod corroded and seriously weakened (2.4.G.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear registration plate font not substantially similar to the prescribed font (6.3.4d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Drag link end ball joint has slight play (2.2.B.1f)

n/s/f bumper damaged

o/s/r tyre has cut not exposing cords

radiator poor condition

rear discs poor

rear pads have been hot

Oil leak

wires hanging underneath vehicle

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

rear cross bars rotton

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

uneven wear to front tyres

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Rear fog lamp not working (1.3.2b)

Front Brake pad(s) wearing thin (3.5.1g)