1991 Subaru 284 4WD Pick Up

Brake pipe corroded, covered in grease or other material All brake pipes covered in underseal (1.1.11 (c))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement Front bush on lower arm (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Moustache bar mounting area corroded (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Torsion bar mounting area corroded (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Torsion bar mounting area corroded (5.3.6 (a) (i))

Oil leak, but not excessive Engine oil leak (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material All covered in underseal (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive Jacking point (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Torsion bar mounting area (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Jacking point (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Torsion bar mounting area (5.3.6 (a) (i))

Oil leak, but not excessive Engine oil leak (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material All covered in underseal (1.1.11 (c))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Brake pedal wearing smooth (1.1.2 (c))

Front Lower Suspension arm corroded but not seriously weakened Both high level of surface rust. (5.3.3 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Brake pedal wearing smooth (1.1.2 (c))

Front Lower Suspension arm corroded but not seriously weakened Both high level of surface rust. (5.3.3 (b) (i))

Horn not working (7.7 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Exhaust emissions carbon monoxide content excessive 4.7%. (8.2.1.2 (b))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Chassis holed by corrosion,differential mounting, (6.1.1 (c) (i))

Offside Rear Axle insecure such that functionality is affected Differential mounting come away from chassis, (5.1.1 (b) (ii)) DANGEROUS

Front Lower Suspension arm corroded but not seriously weakened Both.very rusty. (5.3.3 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Multiple areas been welded,throughout underside.

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Horn not working (7.7 (a) (ii))

Multiple areas been welded,throughout underside.

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 35% (1.2.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides lower arms, (5.3.6 (a) (i))

general corrosion on underside,

Offside Front Outer Body panel corroded and likely to cause injury door skin. (6.2.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill, (5.3.6 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 35% (1.2.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides lower arms, (5.3.6 (a) (i))

general corrosion on underside,

Brake hose has slight corrosion to ferrules all brake hoses retained by cable ties,not insecure, (3.6.B.4e)

Nearside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Nearside Rear Suspension component mounting prescribed area repaired, but not inappropriately swinging arm (2.4.A.3)

Offside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Offside Rear Suspension component mounting prescribed area repaired, but not inappropriately swinging arm (2.4.A.3)

various chassis repairs,been painted and undersealed

Brake hose has slight corrosion to ferrules all brake hoses retained by cable ties,not insecure, (3.6.B.4e)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Nearside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Nearside Rear Suspension component mounting prescribed area repaired, but not inappropriately swinging arm (2.4.A.3)

Offside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Offside Rear Suspension component mounting prescribed area repaired, but not inappropriately swinging arm (2.4.A.3)

various chassis repairs,been painted and undersealed

Emissions not tested exhaust system front too centre gasket blown unable too check emission level (7.3.A.1)

Exhaust has a major leak of exhaust gases front too centre gasket blowing (7.1.2)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Front Brake hose excessively deteriorated securing clip missing (3.6.B.4d)

Nearside Rear Brake hose excessively deteriorated (3.6.B.4d)

Nearside Rear Brake hose excessively deteriorated securing clip missing (3.6.B.4d)

Offside Front Brake hose excessively deteriorated securing clip missing (3.6.B.4d)

Offside Front Brake pad(s) insecure (3.5.1g)

Offside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Service brake: efficiency below requirements (3.7.B.7)

Spare tyre defective spare wheel missing ()

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe leaking (3.6.A.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Front Side repeater not working (1.4.A.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front brake discs in poor condition

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

corrosion to offside front floorpan not prescibed area

front brake discs in poor condition

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside front brake binding (3.7.B.1)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front brake disc excessively pitted (3.5.1h)

Offside Front brake disc excessively pitted (3.5.1h)

Offside front brake juddering severely (3.7.A.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.B.1)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

front brake application uneven (3.7.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

rear vallance is corroded , o/s/r floor starting to corrode ...slight play in both front antiroll bar bushes

Nearside Front Headlamp aim too low (1.6.D2)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Brake hose slightly deteriorated (3.6.B.4d)

front brake disc,s starting to corrode.