1995 BMW 3 Series

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Underside of vehicle showing signs of corrosion

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Underside of vehicle showing signs of corrosion

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Horn not working (7.7 (a))

Nearside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Offside Front Inner Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Front Tyre has ply or cords exposed 225/45/17 (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pad(s) wearing thin very thin - marginal pass (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

bonnet struts weak

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp lens slightly defective condensation in both lamps (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill panel (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

slight play in near side front shock absorber

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp lens slightly defective condensation in both lamps (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill panel (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

slight play in near side front shock absorber

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Offside Front Macpherson strut mounting damaged and seriously weakened top mount split (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output condensation (4.1.4 (b))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive floor pan (7.1.1 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front fog lamps inop

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive floor pan (7.1.1 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front fog lamps inop

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Exhaust has a major leak of exhaust gases manifold (6.1.2 (a))

Horn not working (7.7 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Position lamp not working (4.2.1 (a))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

hand brake travel nearing limit

nearside washer jet inoperative

Nearside Front position lamp(s) deteriorated, but still visible from a reasonable distance (1.1.A.3d)

Nearside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Headlamp aim too low both (1.8)

Nearside Front position lamp(s) deteriorated, but still visible from a reasonable distance (1.1.A.3d)

Nearside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Nearside washer jet inop

Nearside Headlamp aim too high (1.8)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp aim too high and too far to the right. (1.8)

Nearside washer jet inop

hi level stop lamp inop

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Registration plate lamp not working (1.1.C.1d)

Stop lamp not working hi level (1.2.1b)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Items removed from driver's view prior to test

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nail in nearside rear tyre