1990 Peugeot 205

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Both rear outer sills (5.3.6 (a) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Both rear outer sills (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (3.5.1g)

Small noise at offside Front wheel

Battery insecure (1.9.1)

Nearside Direction indicator not working (1.4.A.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

Small noise at offside Front wheel

Small noise at offside front wheel

Nearside Front Direction indicator not working (1.4.A.2c)

Small noise at offside front wheel

Exhaust emits excessive dense blue smoke during acceleration (7.3.A.2c)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Headlamp aim too low (1.8)

brake fluid has high water content advise renewal

o/s inner driveshaft gaiter split

bleed nipple broken off o/s/f

brake fluid has high water content

front brake discs look as though they are below min thickness, advise inspection

n/s/r bump stop missing

rear washer no water

Brake pedal creeps down when held under pressure (3.3.B.1a)

Nearside Rear Brake pipe leaking (3.6.A.1)

1 side lamp bulb out o/s/r (2 fitted)

brake fluid has high water content