2000 Toyota MR2

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Seat belt anchorage prescribed area is inadequately repaired floor (7.1.1 (a) (i))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Service brake excessively binding both front (1.2.1 (f))

Sub-frame corroded and seriously weakened o/s/rear and n/s/rear (5.3.3 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material both front and rear (1.1.11 (c))

Offside Front Brake hose slightly twisted (1.1.12 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Suspension arm ball joint dust cover severely deteriorated both front (5.3.4 (b) (i))

all car heavely underseald

both sill welds not visable

radiator support corroded

Brake disc worn, pitted or scored, but not seriously weakened all discs (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material all pipes (1.1.11 (c))

under side of car heavily under seald

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

n/s sill showing signs of corrosion

offside front strut top bearing

unable to fully inspect all brake pipes due to grease

Nearside Front Steering locking device missing (2.2.C.1g)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

nearside sill holed and corroded

offside front top strut bearing

unable to fully inspect brake pipes due to grease

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim too high (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside front brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

rear subframe corroded

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Rear fog lamp does not emit a steady red light (1.3.2e)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)