1991 Rover Mini

Brakes imbalanced across an axle (3.7.B.5b)

Direction indicator slightly discoloured (1.4.A.2f)

Exhaust clamps low to the ground

Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake cable locking device insecure (3.5.1l)

Nearside Front Brake hose twisted (found during steering lock to lock check) (2.2.D.2b)

Nearside Rear Sub-frame attachment bracket/mounting bolt missing (2.4.G.1)

Offside Rear Sub-frame attachment bracket/mounting bolt missing (2.4.G.1)

Offside Rear Trailing arm attachment bracket/mounting insecure (2.4.G.1)

Braking system leaking (3.6.A.1) DANGEROUS

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

n/S/fouter c.v boot clip fouling hub. Hand brake cable not routed in quadrant (centre).O/s/r flexible hose insecure. Front bumper insecure. Front lower engine steady bar detached. Exhaust fouling rear subframe. Centre exhaust support bracket loose.

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust has a major leak of exhaust gases (7.1.2)

Front position lamp(s) not working (1.1.A.3b)

Fuel tank insecure (7.2.1)

Nearside Front brake caliper securing device loose (3.5.1j)

Nearside Rear Brake pipe inadequately supported (3.6.B.1)

Nearside Rear Sub-frame attachment bracket/mounting bolt missing (2.4.G.1)

Offside Front Shock absorber insecure (2.7.2b)

Offside Rear Brake pipe leaking (3.6.A.1)

Offside Rear Radius arm attachment bracket/mounting insecure (2.4.G.1)

Offside Rear Road wheel distorted (4.2.A.1a)

Offside Rear Sub-frame attachment bracket/mounting insecure (2.4.G.1)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Steering component is not secure to the vehicle structure (2.2.B.1a)

rear brake application uneven (3.7.B.2)

3loose clips on n/s/f drive shaft. o/s wiper blade split.

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

n/S/fouter c.v boot clip fouling hub. Hand brake cable not routed in quadrant (centre).O/s/r flexible hose insecure. Front bumper insecure. Front lower engine steady bar detached. Exhaust fouling rear subframe. Centre exhaust support bracket loose.

FRONT TO REAR METAL BRAKE PIPE REAR CONNECTOR NUT CROSS THREADED

Brake performance not tested (3.7.A.1)

Direction indicators flashing more than 120 times a minute (1.4.A.2g)

Emissions not tested (7.0)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Position lamp switch faulty (1.1.A.1)

Radius arm has excessive play in a pin/bush (2.4.G.2)

Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Service brake: efficiency below requirements (3.7.B.7)

Shock absorber has negligible damping effect (2.7.5)

Steering arm damaged and unserviceable (2.2.C.1d)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

driver door window does not open

engine idle speed requires attention soon

exhaust catching on body requires attention

oil leak

rear exhaust section requires further securing soon

rear valance corroded in non-percribed area

slight play in front ball joints

various body pannels showing signs of corrosion

Nearside Front Body has slight corrosion (6.1.B.2)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Body has slight corrosion (6.1.B.2)

Offside Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Hazard warning tell tale not working correctly (1.4.B.1e)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Windscreen wiper blade insecure (8.2.2)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear fog lamp tell tale not working (1.3.1b)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)