1991 Rover Mini

Nearside Front Subframe mounting prescribed area fractured significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension arm damaged and seriously weakened (5.3.3 (b) (i))

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front All position lamps not working (1.1.A.3b)

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Front Direction indicators missing (1.4.A.2b)

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Rear fog lamp not working (1.3.2b)

Centre Exhaust system not adequately supported (7.1.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Body has a sharp edge caused by damage (6.1.C.1)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Front Brake pad(s) wearing thin (3.5.1g)

both front floors corroded

front brake discs wearing thin

both steering rack gaitors cracking.

n/s/r tyre on limit.

o/s/r floor corroded.

exhaust system loose and noisey. †both front tyres on legal limit. †play in both bottom ball joints.

Hazard warning switch faulty (1.4.B.1d)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear brake recording little or no effort (3.7.B.5a)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)