1991 Mazda MX-5

Nearside Front Track rod end ball joint has slight play inner & outer tie rod (2.1.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Track rod end ball joint has slight play inner & outer tie rod (2.1.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch to inner sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

under floor chassis rails damaged and corroded due to lower than normal car

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced OUTER SILL, INNER SILL AND TO JACKING POINT. CLOSE TO SEAT BELT MOUNTING POINT & SUSPENSION MOUNTING (6.1.1 (c) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Coil spring modified but not seriously weakened N/S/F, N/S/R & O/S/R (5.3.1 (d) (i))

Front Tyre slightly damaged/cracking or perishing N/S & O/S (5.2.3 (d) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material CORRODED FROM N/S/R FLEXI BRAKE PIPE OVER REAR DIFF TO BRAKE COMPENSATER (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen wiper blade defective (3.4 (b) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

n/s inner rack joint

n/s rear disc slight corrosion

oil leak

rear inner sills slight corrosion

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle 95% (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

n/s inner rack joint

n/s rear disc slight corrosion

oil leak

rear inner sills slight corrosion

Nearside Body has slight corrosion Outer sill (6.1.B.2)

the rear number plate is in poor condition

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

NS rear brake pads close to minimum thickness failure criteria

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside Front Upper Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Upper Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

both rear outer sills corroded

Nearside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

front number plate in poor condition