1990 Subaru Justy

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front front brake juddering severely (3.7.A.2b)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front front brake juddering slightly (3.7.A.2b)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

alternator belt perished

both rear tyres slightly perished

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Near side reverse light not working

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak

Nearside front brake juddering slightly (3.7.A.2b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside front brake juddering slightly (3.7.A.2b)

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both rear wheel arches rusty

offsise front wing rusted in bottom corner (by drivers door)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both rear wheel arches rusty

offsise front wing rusted in bottom corner (by drivers door)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

parts of chassis exposed and starting to show surface rust

rear wheel arces starting to corrode

rust at o/s/f sill and bottom of wing

Nearside Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Outer Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Outer Rear Upper Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Outer Rear Upper Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Shock absorber has a slightly reduced damping effect (2.7.5)