1998 Toyota MR2

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor & sill (6.1.1 (c) (i))

Offside Headlamp aim too far to the right (4.1.2 (a))

Offside Integral body structure is fractured and structural rigidity is significantly reduced floor & sill (6.1.1 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength boot floor (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor & sill (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front All direction indicators slightly discoloured (4.4.3 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened both corroded badly (1.1.14 (a) (ii))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive boot floor (5.3.6 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both corroded badly (1.1.14 (a) (ii))

Windscreen wiper blade defective both worn/deteriorated (3.4 (b) (i))

o/s door check strap missing

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

front and rear discs weathered

under trays fitted

Brake hose has slight corrosion to ferrules all (3.6.B.4e)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

front and rear discs weathered

Brake hose has slight corrosion to ferrules (3.6.B.4e)

all coil springs corroded

Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Coolant leak

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

coil spring corroded (2.4.C.1b)

outer sill corroded o/s

under vehicle heavily corroded on components

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Headlamp aim too high (1.8)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

3 point harness type seat belts fitted to non standard mounting with smaller bolts

Nearside Front Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front Front position lamp(s) incorrect colour (1.1.A.3e)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

3 point harness type seat belts fitted to non standard mounting with smaller bolts