1991 Mercedes-benz 420

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (7.1.2)

Steering column shaft has slight end float (2.1.3)

both power steering drive belts deterioating

nearside front chassis corroding

rear crossmember corroding near anti-rll bar fixing points

Battery insecure (1.9.1)

Nearside Side repeater insecure (1.4.A.2b)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Side repeater not working (1.4.A.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Steering column shaft has slight end float (2.1.3)

both power steering belts deterioating

nearside front chassis corroding

rear crossmember corroding near anti-roll bar fixing points

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust engine idle speed too high (7.3.A.2a)

Front registration plate insecure (6.3.1b)

Nearside Front Lower Body has a projection caused by damage (6.1.C.1)

Nearside rear brake binding (3.7.B.1)

Offside Front Lower Body has a projection caused by damage (6.1.C.1)

Offside Rear fog lamp not working (1.3.2b)

Offside rear brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Steering column shaft has slight end float (2.1.3)

both front wings showing signs of filler

brake warning light on

Exhaust emits blue smoke during acceleration (7.3.A.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear position lamp(s) not working (1.1.A.3b)

Exhaust emits blue smoke during acceleration (7.3.A.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Body has a sharp edge caused by corrosion (6.1.C.1)

Brake pedal has insufficient reserve movement (3.3.A.5)

Brake performance not tested (3.7.A.1)

Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Fuel pipe leaking (7.2.3)

Nearside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front coil spring fractured (2.4.C.1a)

Nearside Headlamp aim too far to the left (1.8)

Nearside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Headlamp aim too low (1.8)

Offside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

battery insecure