1991 Saab 900

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive tie bar mounting (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear floor and sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength tie bar (5.3.6 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Headlamp reflector slightly defective (4.1.1 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Brake hose excessively deteriorated (1.1.12 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength tie bar (5.3.6 (a) (i))

Offside Headlamp reflector slightly defective (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering pipe/hose has slight seepage (2.1.5 (a))

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Windscreen washer not working (3.5 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering pipe/hose has slight seepage (2.1.5 (a))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Headlamp has a product on the light source so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Nearside Headlamp aim too low (1.8)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim too low (1.8)

Offside Rear Brake hose twisted (3.6.B.4c)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

boot floor corroding

Body has a sharp edge caused by corrosion tailgate (6.1.C.1)

Nearside Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded inner arch (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded inner arch (5.2.6)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Side repeater incorrect colour (1.4.A.2f)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

boot floor corroding

Oil leak ()

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive tie bar (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm (2.4.A.3)

Parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.D.3b)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

nearside handbrake percentage low

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

nearside hanbrake percentage low

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Panhard rod locating pin insecure (2.4.G.3a)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

nearside hanbrake percentage low

Offside Stop lamp not working (1.2.1b)

Direction indicators not working (1.4.A.2c)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)