1997 Mazda MX-5

Anti-roll bar pin or bush excessively worn both rear mounting (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis/floor (5.3.6 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively both front (3.4 (b) (ii))

Brake pedal wearing smooth (1.1.2 (c))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive floor to sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Suspension arm corroded but not seriously weakened both rear lower (5.3.3 (b) (i))

Tyre worn close to legal limit/worn on edge both front on outer edge (5.2.3 (e))

grinding noise from offside rear wheel

offside front lower wing loose

windscreen chipped

Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced below headlight (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis leg (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

entire underside of vehicle heavily undersealed

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge nearside and offside, wearing inner edges (5.2.3 (e))

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect weak damping (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Anti-roll bar insecurely attached (5.3.3 (a) (i))

Front Tyre worn close to legal limit/worn on edge nearside and offside, wearing inner edges (5.2.3 (e))

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect weak damping (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Headlamp beam starting to deteriorate.

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Under-trays fitted obscuring some underside components

rear exhaust deteriorated

Nearside Front Headlamp insecure (1.7.3)

Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Under-trays fitted obscuring some underside components

front brake discs slightly worn

front wiper blade rubbers detertiorated

rear exhaust deteriorated

handbrake travel high

Brakes imbalanced across an axle (3.7.B.5b)

Nearside front brake binding (3.7.B.1)

Offside Rear Rear fog lamp missing (1.3.2a)

Rear fog lamp switch faulty (1.3.1a)

Rear registration plate obscured (6.3.1d)

handbrake travel high

Brakes imbalanced across an axle (3.7.B.5b)

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Rear fog lamp not working (1.3.2b)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Brake pad(s) wearing thin (3.5.1g)