1990 Nissan Micra

Front Brake hose slightly deteriorated both sides (1.1.12 (b) (ii))

Front Coil spring corroded both sides (5.3.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge perishing (5.2.3 (e))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases down pipe flexible section (6.1.2 (a))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

rear brakes weak

Both inner sills slight corrosion

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material to hose (1.1.11 (c))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

both rear brake pipes to hoses slight corrosion

slight exhaust blow centre section

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

both rear brake pipes to hoses slight corrosion

slight exhaust blow centre section

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

slight exhaust blow rear exhaust box

Nearside Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Exhaust system not adequately supported (7.1.1)

corrosion to inner and outer sills,suspension mounts,floorpans

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)