1991 Rover 416

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Underbody corrosion

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Underbody corrosion

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Rear Direction indicator not working (1.4.A.2c)

Offside Rear Trailing arm insecure (2.4.G.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

slight seepage waterpump

Front registration plate deteriorated (6.3.1d)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Inner Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)