1991 Rover 416

Nearside Inner Front Ball joint has excessive play (2.2.B.1f)

Nearside Rear Body has a sharp edge caused by damage (6.1.C.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Inner Front Ball joint has excessive play (2.2.B.1f)

Offside Outer Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Steering system slightly rough (2.2.D.1)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Rear Stop lamp not working (1.2.1b)

Offside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

O/S FRONT WHEEL OUT OF LINE POSSIBLE BENT LOWER STEERING ARM.

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Spare tyre defective

Front registration plate character(s) not correctly formed (6.3.4b)

Nearside Front Windscreen wiper not operating automatically when switched on (8.2.1b)

Nearside Lower Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Lower Torque/reaction arm has excessive play in a pin/bush (2.4.G.2)

A torque/reaction arm in this case may be known as the anti-roll bar.

Passenger door mirror missing.

Rear number plate has slight seperation likely to have been caused by water. †Rear bumper ends and drivers front bumper end not secured properly.