1991 Peugeot 405

Front Shock absorber has a slightly reduced damping effect (2.7.5)

Front coil spring corroded (2.4.C.1b)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

battery insecure

lower rear engine mounting has excessive play

offside rear wheel slightly binding

rear inspection plates are missing from underneath of vehicle leaving 2 large holes into vehicle

windscreen has scratches in the drivers view but are only considered light

Anti-lock braking system warning lamp does not illuminate (3.4.1b)

Nearside Front Anti-lock braking system wiring excessively damaged (3.4.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint is insecure (2.5.C.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Side repeater not working (1.4.A.2c)

Front Shock absorber has a slightly reduced damping effect (2.7.5)

Front coil spring corroded (2.4.C.1b)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

battery insecure

lower rear engine mounting has excessive play

offside rear wheel slightly binding

rear inspection plates are missing from underneath of vehicle leaving 2 large holes into vehicle

windscreen has scratches in the drivers view but are only considered light

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim too high (1.8)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Registration plate lamp not working (1.1.5c)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

offside headlamp stone holed + reflector surface deteriorating.

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Side repeater not working (1.4.A.2c)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

offside headlamp stone holed + reflector surface deteriorating.