1990 Toyota MR2

Nearside Front Lower Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Shock absorbers has light misting of oil both rear shock absorbers have a light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Shock absorbers has a reduced damping effect Both (5.3.2 (d))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Anti-roll bar linkage ball joint has slight play both sides (5.3.4 (a) (i))

Front Service brake fluctuating, but not excessively both sides (1.2.1 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Service brake fluctuating, but not excessively both (1.2.1 (e))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear body strengthening bar corroded

Nearside Rear park brake performance low, looks like cable is over adjusted

Offside Front Tyre slightly damaged/cracking or perishing cut in inner side wall (5.2.3 (d) (ii))

both inner sills and rear floor pans corroded

both rear outer sills corroded

radiator corroded

Nearside Front tyre perished

Nearside Rear tyre perished

Offside Front tyre perished

Offside Rear tyre perished

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front tyre perished

Nearside Rear tyre perished

Offside Front tyre perished

Offside Rear tyre perished

Nearside Front tyre perished

Nearside Rear tyre perished

Offside Front tyre perished

Offside Rear tyre perished

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front brake caliper has restricted free movement (3.5.1k)

n/s front and o/s/front coil springs rusty

Exhaust emits visible black smoke at idle (7.3.A.2b)

Nearside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Outer Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

n/s front and o/s/front coil springs rusty

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

all front and rear steering and suspension joints corroded

catalyst corroded badly

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Front Headlamp aim too high when the centre of the headlamp is above 850mm from the ground (1.6.B3)