2013 Mazda MX-5

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Rear Tyre worn close to legal limit/worn on edge x2 nsr osr (5.2.3 (e))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Child Seat fitted not allowing full inspection of adult belt nearside and offside rear

some damage to offside rear reflecctor

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

sill poorly repaired nearside rear

both rear to front chassie members crushed and squashed out of correct shape

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

both rear to front chassie members crushed and squashed out of correct shape

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside handbrake effort could be improved

Offside chassie crushed close to the same level as the floor

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside handbrake effort just passes

Front Brake pads are getting low on friction lining material.

Rear Brake pads are getting low on friction lining material.

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp not working on main beam (1.7.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Offside Body has slight corrosion (6.1.B.2)

Centre Rear Stop lamp not working (1.2.1b)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear fog lamp emits a light other than red (1.3.2e)

Nearside Body has slight corrosion (6.1.B.2)

Nearside Rear Body has slight corrosion (6.1.B.2)

Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear registration plate character(s) sloping (6.3.4b)

Nearside Front Braking system leaking (3.6.A.1) DANGEROUS

Nearside Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Offside Front An item not tested (Manual)

Offside Rear fog lamp not working (1.3.2b)

Offside front brake binding (3.7.B.1)

Nearside Front brake disc slightly pitted (3.5.1h)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

brake disc excessively pitted (3.5.1h)

Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp aim too low (1.6.D2)

Offside Front Headlamp aim too far to the left (1.6.D3)

Offside Front Headlamp aim too high (hotspot upper edge above the horizontal 0% line) (1.6.D1)