1990 Cagiva Mito

exhaust slightly leaking from cylinder head

front and rear tyres nearing minimum limit

front brake slightly binding

front master cylinder reservior cracked

Drive chain worn to excess (6.2.1e)

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Rear suspension bush has excessive free play (2.4.A2a(i))

front and rear tyres nearing minimum limit

front brake slightly binding

front master cylinder reservior cracked

sprockets worn

Coolant leak

Nearside Front Headlamp damaged but function not impaired (1.2.3a)

Offside Front Headlamp deteriorated but function not impaired (1.2.3a)

Front Headlamp aim too low (1.6)

Nearside Front Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars (2.1.2b)

Offside Front Steering control handlebar movement restricted by cables caught on a projection (2.1.2c)

Rear Rear shock absorber has inadequate damping effect. (2.4.A.3b)

l/h foot peg broken, has half left

r/h switch gear loose. (turns with throttle)

Drive chain sprocket carrier worn to excess (6.2.1e)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Horn not working (1.7.3a)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre worn close to the legal limit (4.1.3(ii))

front tank securing strap incorrect but not loose

instrument housing loose

nearside front fork seal deterorated not leaking

rear seat panel missing

rear sprocket cush drive plate broken

Front Brake disc(s) slightly scored (3.2.A1l)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Wheel corroded but not significantly reducing the original strength (4.2.1a)

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear Wheel corroded but not significantly reducing the original strength (4.2.1a)

nearside rider footrest slight damage †gearchange lever repaired

Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.2)

Rear Locking devices not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Rear Stop lamp remains on when the brake is released (1.3.1e)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))