2000 Mazda MX-5

Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Upper Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Headlamp aim too low both (4.1.2 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Parking brake: efficiency below requirements (3.7.B.7)

Brake pipe excessively corroded (3.6.B.2c)

Brake pipe excessively corroded (3.6.B.2c)

Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Upper Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear brake disc slightly pitted (3.5.1h)

Suspension joint offside upper dust cover split/missing

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Rear fog lamp insecure (1.3.2a)

Rear Rear fog lamp not working (1.3.2b)

Front brake drum slightly scored (3.5.1h)

Offside Vehicle structure has slight damage (6.1.A.1)

Rear brake drum slightly pitted (3.5.1h)