1990 Peugeot 205

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake pipe corroded, covered in grease or other material too rear @ rear (1.1.11 (c))

Nearside Front Brake disc contaminated (1.1.14 (b))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material too rear @ rear (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

rear brakes uneven application.

Brakes imbalanced across an axle (3.7.B.5b)

Offside rear brake application uneven (3.7.B.2)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front brake disc contaminated by grease (3.5.1h)

Offside Rear wheel cylinder leaking (3.6.A.1)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

o/s rear brake backing plate damp ?

dampness around n/s front cv boot

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Oil leak

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Exhaust has a minor leak of exhaust gases (7.1.2)