2000 BMW 3 Series

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill and floor (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill and floor (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

exhaust poor in places

fog light does not light up on dash

front brake hoses perished

o/s/f outer sill holed

oil leak

rear discs poor

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust catalytic converter obviously modified (8.2.1.1 (a))

Headlamp aim too low both (4.1.2 (a))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

exhaust poor in places

fog light does not light up on dash

front brake hoses perished

o/s/f outer sill holed

oil leak

rear discs poor

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor (2.4.A.3)

Undertray and sill covers fitted

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor (2.4.A.3)

Undertray and sill covers fitted