2004 Ford Transit

Front Brake pipe corroded, covered in grease or other material to rear various places (1.1.11 (c))

Front Suspension spring mounting prescribed area is corroded but not considered excessive and rear sills, chassis and floor (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Offside Front Outer Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Nearside Rear Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Rear Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Nearside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings wing (6.1.B.2)

Nearside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings wing (6.1.B.2)

Offside Rear rear brake binding (3.7.B.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Offside Rear Body has slight corrosion around position lamp (6.1.B.2)

Slight corrosion to rear chassis (around bump stop rubbers)

Axle has inadequate clearance with the bump stop Both rear bump stop insecure (2.4.A.1a)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings around leaf spring mount (both rear) (6.1.B.2)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement Wishbone arm (rear) bush (2.4.G.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Inner wing (6.1.B.2)

Nearside Rear Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Inner wing (6.1.B.2)

Offside Rear Body insecure and dangerous to other road users Bumper insecure (6.1.B.1b)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Inner wing (6.1.B.2)

Offside Rear Parking brake recording little or no effort (3.7.D.3a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pipe slightly corroded Across axle (3.6.B.2c)

Vehicle underneath body/chasis corroding (requires underseal)

Body has a projection caused by damage BOTH SIDE FRONT BUMPER INSECURE (6.1.C.1)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings BOTH SIDE FRONT INNER DOORSTEP (6.1.B.2)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings BOTH SIDE FRONT INNER WING (6.1.B.2)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings BOTH SIDE FRONT UPPER WING (UNDER BONNET) (6.1.B.2)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings BOTH SIDE REAR (AROUND OUTRIGGER) (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings OUTER DOORSTEP (6.1.B.2)

Nearside Front Headlamp aim too low (1.8)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings INNER WING (6.1.B.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings OUTER AND INNER SILL (6.1.B.2)

Offside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings FULL INNER SILL (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings INNER WING (6.1.B.2)

Windscreen washer provides insufficient washer liquid Both front (8.2.3)

Windscreen wiper does not clear the windscreen effectively Both front (8.2.2)

Rear Brake pipe slightly corroded Across axle (3.6.B.2c)

Underneath body and chassis dry/rusty (requires underseal)

All position lamps have light sources not illuminating, but not more than 50% (1.1.A.3b)

Nearside All position lamps have a product on the lenses but not adversely affecting light output (1.1.A.3d)

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Headlamp aim too high (1.8)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

vehicle does not stand level

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Fuel system component leaking (7.2.3)

Headlamp aim too low (1.8)

Offside Rear fog lamp not working (1.3.2b)

registration plate character(s) incorrectly spaced (6.3.4a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Temporary fuel cap fitted

front discs wearing thin

Nearside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Temporary fuel cap fitted

front discs wearing thin

Offside Rear Stop lamp not working (1.2.1b)

Registration plate lamp not working (1.1.5c)