2007 Chevrolet Matiz

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake performance not tested o/s/f brake pad separating (1.2.1 (g))

Offside Front Brake pad(s) incorrectly mounted (1.1.13 (c)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Headlamp has a product on the light source but not seriously reducing light output BOTH (4.1.4 (b))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Headlamp has a product on the light source but not seriously reducing light output BOTH (4.1.4 (b))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Exhaust system flexi pipe flanges corroded / deteriorated

front brake application uneven (3.7.B.2)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake binding (3.7.B.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

front brake application uneven (3.7.B.2)

Offside Rear tyre perishing worn down to 2mm.

Brakes imbalanced across an axle (3.7.B.5b)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

petrol flap will not close

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

petrol flap will not close