2008 Subaru Legacy

Front Exhaust mounting defective (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive whole area (5.3.6 (a) (i))

Offside Front Inner Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive whole area (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced whole vehicle (6.1.1 (c) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps both (4.7.2 (a))

Front Brake pad(s) wearing thin both (1.1.13 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust mounting defective (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Under trays fitted obscuring some testable items

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Exhaust mounting defective (6.1.2 (a))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Rear Exhaust mounting defective (6.1.2 (a))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Headlamp aim too low (4.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front rear bush

Offside Front rear bush

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear fog lamp not working (1.3.2b)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

all four tyres are perished on the tread a little

both front tyres are wearing on inside edge of tread