2012 Yamaha Yzf

Exhaust noisy (8.1.1 (a))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Stop lamp not working (4.3.1 (a) (ii))

Nearside Handlebar fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Rear Suspension component pin or bush excessively worn (5.3.4 (a) (i))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Exhaust noisy (8.1.1 (a))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake caliper slightly damaged but function not impaired wear in the slider mech (1.1.16 (a) (i))

Stop lamp not working no front and rear at all (4.3.1 (a) (ii))

Rear Brake caliper slightly damaged but function not impaired wear in the slider mech (1.1.16 (a) (i))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Drive chain so loose it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Position lamp not working side light front (4.2.1 (a))

Rear Brake lagging in operation (1.2.1 (d))

Rear Rear reflector missing (4.8.2 (a) (ii))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Steering operation restricted in free movement from lock to lock engine speed (2.1.4 (c))

Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Exhaust slightly loose (6.1.2 (a))

Clutch lever shortened. (6.2.1g)

Front indicator lens missing

Nearside Front Front shock absorber has light misting of stanchion (2.3.3)

Nearside Steering control has reduced clearance at full lock not affecting the riders grasp of handlebars touchs fuel tank (2.1.2b)

Rear Exhaust mounting deteriorated. (7.1.1.c)

Steering headbearing has slight free play (2.2.2)

Front Brake component has an inadequate repair fornt brake pivot loose + securing nut missing (3.1.5)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Offside Steering control has Insufficient clearance at full lock affecting the riders operation of the controls front brake lever hitting fairing & being applied (2.1.2b)

Rear Brake caliper(s) insecure mounting rubber missing (3.2.A1j)

Rear reflector on motorcycle missing (1.4.1)

Clutch lever shortened. (6.2.1g)

Front indicator lens missing

Nearside Front Front shock absorber has light misting of stanchion (2.3.3)

Nearside Steering control has reduced clearance at full lock not affecting the riders grasp of handlebars touchs fuel tank (2.1.2b)

Rear Exhaust mounting deteriorated. (7.1.1.c)

Steering headbearing has slight free play (2.2.2)

Clutch lever shortened. (6.2.1g)

Nearside Steering control has reduced clearance at full lock not affecting the riders operation of the controls (2.1.2b)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Steering headbearing has slight free play (2.2.2)

Centre Exhaust mounting does not fully support the exhaust system bolt is loose (7.1.1.c)

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Rear Exhaust mounting missing (7.1.1c) DANGEROUS

Clutch lever shortened. (6.2.1g)

Nearside Steering control has reduced clearance at full lock not affecting the riders operation of the controls (2.1.2b)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Steering headbearing has slight free play (2.2.2)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)