2005 MG ZS

Headlamp has a product on the lens but not seriously reducing light output Both fronts (4.1.4 (b))

Integral body structure is corroded but structural rigidity is not significantly reduced floor area (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement Both rear upper arms inner bushes (5.3.4 (a) (i))

Both front back plates corroded

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Suspension arm pin or bush worn but not resulting in excessive movement Both rear upper top arm inner bushes (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor area (6.1.1 (c) (i))

Both front back plates corroded

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Suspension arm pin or bush worn but not resulting in excessive movement Both rear upper top arm inner bushes (5.3.4 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn axle bush (5.1.2 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 3mm to 2mm slight perishing/cracking to sidewalls (5.2.3 (e))

Suspension arm pin or bush worn but not resulting in excessive movement Both fronts front arm bushes (5.3.4 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement Both rears upper and lower side arm bushes (5.3.4 (a) (i))

Tyre worn close to legal limit/worn on edge Both fronts 3mm (5.2.3 (e))

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Radius arm rubber bush deteriorated but not resulting in excessive movement Both rears upper and lower side arm bushes (2.4.G.2)

Rear exhaust system rear tail box internals broken up baffles centre section corroding deteriorating

Suspension arm rubber bush deteriorated but not resulting in excessive movement Both fronts front arm bushes (2.4.G.2)

Suspension arm rubber bush deteriorated but not resulting in excessive movement Both rears (2.4.G.2)

Vehicle structure has slight corrosion front floorplan underside (6.1.B.2)

Front coil spring corroded (2.4.C.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front coil spring corroded (2.4.C.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

center exhaust deteriated

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside rear brake binding (3.7.B.1)

center exhaust deteriated

o/s/r brake disc shows overheated

Nail in offside rear tyre

front washer jets work with the rear washer switch

Offside Front Tyre worn close to the legal limit (4.1.E.1)

n/s/f tyre wearing inner edge

Offside rear brake binding (3.7.B.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

n/s/f tyre wearing inner edge

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS