2012 Honda Cbf

Handlebar deformed but serviceable (2.2.1 (c) (i))

Suspension arm corroded but not seriously weakened swinging arm (5.3.3 (b) (i))

Wheel alignment slightly misaligned (2.4 (a))

Exhaust noisy (8.1.1 (a))

Forks slightly corroded (2.2.2 (d) (i))

Front fork dust seals corroded

Handlebar deformed but serviceable (2.2.1 (c) (i))

Rear Brake linkage corroded but not seriously weakened (1.1.15 (b))

Rear Suspension arm corroded but not seriously weakened swing arm (5.3.3 (b) (i))

Rear brake arm locking device missing

Wheel alignment slightly misaligned (2.4 (a))

Steering operation fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Front Stop lamp remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Forks slightly corroded (2.2.2 (d) (i))

Front fork dust seals corroded

Handlebar deformed but serviceable (2.2.1 (c) (i))

Rear Brake linkage corroded but not seriously weakened (1.1.15 (b))

Rear Suspension arm corroded but not seriously weakened swing arm (5.3.3 (b) (i))

Rear brake arm locking device missing

Wheel alignment slightly misaligned (2.4 (a))

Exhaust noisy (8.1.1 (a))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Handlebar deformed but serviceable (2.2.1 (c) (i))

front fork dust seals deteriorated

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Nearside Front Dust seal in poor condition

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Headlamp aim too high (4.1.2 (a))

Nearside Front Dust seal in poor condition

front forks dust seals corroded

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))

Rear Drive chain sprocket worn to excess (6.1.7 (c) (i))

Rear Registration plate inscription illegible number plate cracked (0.1 (b))

Drive chain so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

front forks dust seals corroded

cush drive rubbers worn to excess

exhaust silencer fouling rear swing arm

Brake pad(s) close to minimum limit Front pads on/very near limit. Recommend replacement now. (1.1.13 (a))

Front tyre sidewalls perishing.

Front upper fairings missing.

Headlamp dip switch slightly sticky.

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))