2015 Lexmoto Wy

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened disc on legal limit (1.1.14 (a) (ii))

Nearside Front Shock absorber has a light misting of oil shock leaking on limit (5.3.2 (b))

Rear left brake has long travel

steering has upper play suspect bearing

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front wheel bearings slightly rough, no play

Rear Brake lining(s) close to minimum limit (1.1.13 (a))

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Top cowling insecure

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Rear Brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Shock absorber has a slightly worn bush Top shock mount (5.3.2 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Rear Brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Rear Wheel spindle or securing nut(s) so insecure that wheel security or steering control is adversely affected (5.2.1 (c) (ii)) DANGEROUS

Rear Shock absorber has a slightly worn bush Top shock mount (5.3.2 (c))

Rear suspension has slightly reduced damping effect.

ignition switch slightly faulty.

Headlamp aim too low (4.1.2 (a))

Rear Brake lever has insufficient reserve travel (1.1.2 (a))

Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Engine idle speed high.

Front Mudguard insecure

Handlebar fairing slightly loose.

Rear suspension has slightly reduced damping effect.

Slight wear in rear wheel spline.

ignition switch slightly faulty.

Offside Stop lamp not working brake switch (4.3.1 (a) (ii))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Shock absorber has a serious fluid leak L/H (5.3.2 (b))

Shock absorber has negligible damping effect Rear (5.3.2 (b))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))