2004 Citroen Relay

Nearside Rear Tyre worn close to legal limit/worn on edge Perished (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge Perished (5.2.3 (e))

Outer sills deformed

Nearside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

Tyres fitted to vehicle load rating is too low for weight of vehicle

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Seat belt retracting mechanism defective (7.1.2 (e))

Nearside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

Tyres fitted to vehicle load rating is too low for weight of vehicle

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Coolant leak ()

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Suspension component mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded jackin point (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Front Coolant leak ()

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Nearside Front Suspension spring mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nail in offside front tyre

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

n/s driveshaft inner boot is split

Nail in offside front tyre

Oil leak

Brake vacuum build up too slow (3.3.E.6)

Nail in offside front tyre

Oil leak

Emissions not tested (7.0)

Nearside Headlamp aim too high (1.8)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Horn not working (1.6.2a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)