2005 Hyundai Accent

Brake warning device malfunctioning or defective (1.1.4 (a) (i))

Nearside Front Headlamp lens slightly defective Headlamp plastic lens deteriorated (4.1.1 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Headlamp lens slightly defective Headlamp plastic lens deteriorated (4.1.1 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust mounting defective (6.1.2 (a))

Boot full not allowing full inspection of prescribed areas.

Brake warning device malfunctioning or defective (1.1.4 (a) (i))

Central Upper Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Central Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Handbrake has little or no reserve travel left.

Nearside Rear Inner Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Bonnet cable insecure

Brake warning device malfunctioning or defective (1.1.4 (a) (i))

Central Rear Standard fitment seat belt missing ()

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Windscreen damaged but not adversely affecting driver's view Chip (3.2 (a) (i))

Front Headlamp aim projected beam image is obviously incorrect Both (4.1.2 (c))

Bonnet cable insecure

Brake warning device malfunctioning or defective (1.1.4 (a) (i))

Central Rear Standard fitment seat belt missing ()

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Windscreen damaged but not adversely affecting driver's view Chip (3.2 (a) (i))

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Brakes imbalanced across an axle 36% (1.2.1 (b) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened corroded (1.1.14 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

All 4 Tyre's perished

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Headlamp aim too low (1.8)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too low (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)