2006 Toyota Aygo

Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust emits black smoke during acceleration (8.2.1.2 (g))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

surface rust under body

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Rear Brake hose has slight corrosion to ferrule both sides (1.1.12 (f) (i))

both rear trailing arm bushes deteriorated

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe excessively corroded centre main (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded centre main (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

rear parking (secondary) brakes imbalanced (3.7.B.6b)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Rear Registration plate lamp not working (1.1.C.1d)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Stop lamp not working (1.2.1b)