1995 Nissan 300 Zx

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Brake pad(s) wearing thin ON LIMIT !!!! (1.1.13 (a) (ii))

Exhaust catalytic converter missing where one was fitted as standard emissions tested but above limits due to lack of cat . (8.2.2.1 (a))

Rear Service brake excessively binding (1.2.1 (f))

Service brake efficiency below requirements (1.2.2 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Horn not working (7.7 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill (5.3.6 (a) (i))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Brake pipe corroded, covered in grease or other material some (1.1.11 (c))

fuel pipes corroded

Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

park brake travel

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Horn not working (1.6.2a)

Rear fog lamp not working (1.3.2b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

catalystic converters been removed but car not subject to a full cat test

cracks in n/s rear tyre

n/s front tyre wearing on inner edge

Nearside Registration plate lamp not working (1.1.C.1d)

filler in o/s rear outer sill

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

both front tyres scrubbing inner part of the tread