2003 Volkswagen Caddy

Exhaust has a minor leak of exhaust gases centre box (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor pan (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases centre silencer (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Brake pipe corroded, covered in grease or other material at load sensing valve (1.1.11 (c))

Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Brake pipe corroded, covered in grease or other material at load sensing valve (1.1.11 (c))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

rear exhaust rusty

Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside rear brake application uneven (3.7.B.2)

Rear Brake load sensing valve seized (3.6.E.3)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

rear exhaust rusty

rear exhaust silencer deteriorated but not blowing

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Exhaust system not adequately supported (7.1.1)

rear exhaust silencer deteriorated but not blowing

Offside Stop lamp not working (1.2.1b)

both n/s tyres have nails in

center exhaust mtg detatched from pipe