2013 Mercedes-benz C

Front Brake pad(s) wearing thin Wait for light, change discs with pads. (1.1.13 (a) (ii))

Front Upper Brake hose has slight corrosion to ferrule Both sides. (1.1.12 (f) (i))

Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Caster, both sides. (5.3.4 (a) (i))

Nearside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake hose has slight corrosion to ferrule Both sides. (1.1.12 (f) (i))

Nearside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Trays fitted not allowing full inspection.

Emissions too clean to register.

Front Upper Brake hose has slight corrosion to ferrule Both sides. (1.1.12 (f) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Trays fitted not allowing full inspection.

Emissions too clean to register.

Front Upper Brake hose has slight corrosion to ferrule Both sides. (1.1.12 (f) (i))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Trays fitted not allowing full inspection.

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Lower Coil spring corroded Both sides. (5.3.1 (b) (i))

Rear Tyre worn close to legal limit/worn on edge Both sides. (5.2.3 (e))

Trays fitted not allowing full inspection.

Offside Front Headlamp insecure (4.1.1 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Lower Coil spring corroded Both sides. (5.3.1 (b) (i))

Rear Tyre worn close to legal limit/worn on edge Both sides. (5.2.3 (e))

Trays fitted not allowing full inspection.

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Trays fitted not allowing full inspection.

under trays and engine covers fitted, obscuring certain components.

UNDERBODY TRAYS AND ENGINE COVERS FITTED, OBSCURING CERTAIN COMPONENTS.

DUE TO LOW EMMISION VALUES, NO PRINTOUT ISSUED.

UNDERBODY TRAYS AND ENGINE COVERS FITTED,RESTRICTING AN INSPECTION OF CERTAIN COMPONENTS.

engine and undertray covers fitted obscuring some components

no printout produced due to low emissions