2015 Toyota Aygo

Coil spring corroded all 4 (5.3.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material In front of axle (1.1.11 (c))

Rear Axle corroded

Rear Brake hose has slight corrosion to ferrule os and ns (1.1.12 (f) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced os and ns rear axle mounts (6.1.1 (c) (i))

Rear Lower Integral body structure is corroded but structural rigidity is not significantly reduced Os and ns sill (6.1.1 (c) (i))

Nearside Rear Brake pipe excessively corroded to wheel cylinder (1.1.11 (c))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Coil spring corroded all 4 (5.3.1 (b) (i))

Nearside Brake pipe inadequately clipped or supported front to rear (1.1.11 (d) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material In front of axle (1.1.11 (c))

Rear Axle corroded

Rear Brake hose has slight corrosion to ferrule os and ns (1.1.12 (f) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced os and ns rear axle mounts (6.1.1 (c) (i))

Rear Lower Integral body structure is corroded but structural rigidity is not significantly reduced Os and ns sill (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting prescribed area (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm pin or bush excessively worn rear wishbone bush (5.3.4 (a) (i))

Offside Rear Brake performance unable to be tested axle mounting heavily corroded/weakened risk of further damage (1.2.1 (g))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected axle mount prescribed area (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting prescribed area (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Oil leak, but not excessive inner diff/driveshaft seal (8.4.1 (a) (i))

Offside Front Oil leak, but not excessive diff seal (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Oil leak, but not excessive diff seal (8.4.1 (a) (i))

Nearside Front Road wheel slightly distorted inner edge (5.2.2 (c) (i))

Offside Front Inner Oil leak, but not excessive diff seal (8.4.1 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords outer side wall (5.2.3 (d) (i))

Nearside Front Road wheel slightly distorted inner edge (5.2.2 (c) (i))

Offside Front Inner Oil leak, but not excessive diff seal (8.4.1 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Tyre pressure monitoring system warning lamp indicates a fault (5.2.3 (h) (i))

Front Brake pad(s) wearing thin (3.5.1g)