2008 Toyota Aygo

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under sill (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner wing (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under sill (5.3.6 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Emissions unable to be completed CO too high (8.2.1.2 (d))

Offside Front Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer jacking point (6.1.1 (c) (i))

Offside Rear Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point (6.1.1 (c) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear shock absorber casing corroded

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear shock absorber casing corroded

Offside Rear Outer Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i))

Offside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear shock absorber casing corroded

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear shock absorber casing corroded

Brake hose has slight corrosion to ferrule All (1.1.12 (f) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Macpherson strut corroded and seriously weakened (5.3.3 (b) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer Sill (5.3.6 (a) (i))

Offside Front Macpherson strut corroded and seriously weakened (5.3.3 (b) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer Sill (5.3.6 (a) (i))

Brake hose has slight corrosion to ferrule All (1.1.12 (f) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Coil spring mounting corroded and seriously weakened Lower shock absorber platform (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Offside Front Coil spring mounting corroded and seriously weakened Lower shock absorber platform (5.3.1 (b) (i))

Offside Rear Outer Brake pipe excessively corroded Flexi to cylinder(Marked) (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Brake hose has slight corrosion to ferrule All front & rear (1.1.12 (f) (i))

Coolant level low

Front Brake disc worn, pitted or scored, but not seriously weakened Inner surface (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced Outer sill (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material Before beam axle (1.1.11 (c))

Nearside Rear Outer Brake pipe corroded, covered in grease or other material Flexi to cylinder (1.1.11 (c))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced Outer sill (6.1.1 (c) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material Before beam axle (1.1.11 (c))

Offside Rear Tyre slightly damaged/cracking or perishing Perishing (5.2.3 (d) (ii))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Exhaust system insecure (6.1.2 (a))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Stop lamp(s) switch does not operate in accordance with the requirements (4.3.2 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Suspension arm pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake pipe corroded, covered in grease or other material Both front to rear (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement REAR BUSH (5.3.4 (a) (i))

Tyre slightly damaged/cracking or perishing Both rear (5.2.3 (d) (ii))

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Front front brake application uneven (3.7.B.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Centre Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)